31
11. Once the program has f inished learning
1/2 power, the LCD will then show <SET
M A N UA L 1/4>. T h e p r o c e d u r e w i l l r e p e at
until the program has f inished learning
to 1/128 power.
12. If your ash does not support a
particular power level, turn the dial to
<SKIP> and then press . The program
will skip learning that power level and
go to the next level. The more power
levels that have been learned, the more
accurate the learned prof ile will be.
13. Once the V6 has f inished f iring the ash
i n t h e st e p < S E T M A N UA L 1/1 28 >, t h e L C D
s c r e e n w il l s h o w < B A C K T O T T L M O D E >.
C h a n g e t h e a s h m o d e t o T T L a n d p r e s s
. The V6 will then f ine tune different
power levels and f i r e t h e a s h m a n y
times for approximately 2-3 minutes.
14. When the learning is f inished, the LCD
s c r e e n w il l s h o w <F L A S H P R O F I L E N A M E >.
Enter a prof ile name with 1-6 letters or
numbers. Please enter a unique prof ile
name that has not been used in other
custom prof iles. Turn the selection dial
to choose from A-Z and 0-9 and press
for every character selected.
To Next Page
Loading...
