30
8. The V6 will test f ire the ash twice and
determine whether the ash is eligible
fo r t h e a s h l e a r n i n g p r o g r a m . If t h e
a s h i s n o t e l i g i b le, t h e L C D s cr e e n w i l l
show <FLASH LEARNING NOT SUPPORTED>.
Tips: There is a chance that the distance
b e t w e e n t h e a s h a n d t h e r e e c tiv e s u r f a c e
is too short or too long. Relocate the
ash as specif ied in step 2. Also make
s u r e t h a t y o u h a v e c h o s e n t h e c o r r e c t a s h
system in step 7.
9. If the ash is eligible for the learning
program, the LCD screen will show <SET
MAX GN> and the default number 45. Turn
the selection dial until the LCD screen
shows the maximum guide number (in
meters) of your ash. Press .
10. The LCD screen will then show <SET
M A N UA L 1/2> w it h a h i g h l i g h t e d o p tio n
<G O>. S w it c h y o u r a s h t o M a n u a l m o d e
at 1/2 power and press . The V6 will
trigger your ash a few times as it
le a r n s, w h i l e s h o w i n g <L E A R N I N G 1 /2 > o n
the LCD screen.
To Next Page
Loading...
