46
At the Lo Power level, the relative power
output of a ash triggered by the V6 is
roughly equal to 1/256. The difference
between 1/128 and 1/256 power outputs may be
hardly detected by ash meter, but the
extremely short f iring duration helps
freeze faster-than-lightning moments and is
ideal for high-speed photography.
To enable Lo Power:
1. Switch on the V6 in TX mode and press .
T u r n t h e s e le c tio n d i a l t o < L o P O W E R >
and press . Turn the selection dial to
<ON> and press .
2. Once the Lo Power is enabled, the Lo
Power will be shown as <Lo> at one step
below 1/128 power in the relative power
mode, or one step below the lowest power
of each group in the absolute power mode.
3. To disable the Lo Power output, follow
step 1 to enter the Lo Power menu. Turn
t h e s el e ctio n d i a l t o < O F F > a n d
press .
12.4
Lo Power
To Next Page
Loading...
