6
DURESS CODE
If checked, your security system has a "DURESS CODE" option. If so, this code may be
programmed to send a special message to the central monitoring station if you are forced to
arm or disarm your security system against your will. Check with your Installing/Servicing
company to see if this option has been enabled for your system.
PROGRAMMING ARM/DISARM CODES
The security system can be armed and disarmed by the Master code (User Code #1), and up
to 13 auxiliary codes. All codes must have 4 digits. These Auxiliary codes are individually
numbered from 2 to 14. (NOTE: If your system is programmed for a DURESS code on page
5, user code #7 will not be available). If Auxiliary codes are desired, they must be programmed
individually. Codes 2 through 7 can be changed by the procedures described below, while
codes 8 through 14 can only be changed by your installing company. Only persons knowing
the master code can assign or change auxiliary codes 2 through 7. (See programming
Auxiliary codes below).
CHANGING THE MASTER CODE - The Master Code is user code #1, and must be
programmed by referring to it as code #1. For example, if the Master code is [1]-[2]-[3]-[4], and
you want to change it to [5]-[3]-[4]-[2], the programming sequence would be as follows. Press
[r]-[1]-[#], (this enters programming for user #1). Then enter the current Master Code of
[1]-[2]-[3]-[4]. Press [r]-[1]-[#] to verify user #1 programming. Now enter your new Master
Code of [5]-[3]-[4]-[2], and exit programming with [r]-[1]-[#]. The entire sequence would
consist of pressing 17 keys as follows:
[r]-[1]-[#] - [1]-[2]-[3]-[4] - [r]-[1]-[#] - [5]-[3]-[4]-[2] - [r]-[1]-[#]
PROGRAMMING AUXILIARY CODES 2 THROUGH 7- In order to program Auxiliary Codes
2 through 7 you must know the Master code. As stated earlier, each auxiliary code has its own
unique number from 2 through 7, and must be referred to by its number. It is programmed
much like the Master Code. For example, to program Auxiliary user code #2, the sequence
would be as follows:
[r]-[2]-[#] - [1]-[2]-[3]-[4] - [r]-[2]-[#] - [ ]-[ ]-[ ]-[ ] - [r]-[2]-[#]
(New Code)
REMOVING AUXILIARY CODES - To remove an Auxiliary user code, use the sequence
above, and program the new code as the Master Code.
RESETTING YOUR SECURITY CONTROL CENTER
In the event of a system malfunction in the Security Control Center, press the [#] (reset) key
on the keypad control. This should reset the code sequence and restore normal operation. If
the problem persists, call the service number located on page 1 of this booklet for service.
AUDIBLE ALARM SOUNDS
FIRE: Steady siren or pulsing bell (see page 1)
INTRUSION & PANIC: Yelp siren or steady bell (see page 1)
To Next Page
