Vehicle Personalization
Memory
Seat
If your vehicle has this
feature, then the controls
for the memory function
are located on the
driver’s door.
These buttons are used
to
program and recall memory
settings for the driver’s seat, throttle and brake
pedals, both the driver’s and passenger’s outside mirror,
and the radio station presets. The settings for these
features can be personalized for both driver
1
and
driver
2.
Driver
1
or driver
2
corresponds
to
the memory
buttons labeled
1
and 2 on the driver’s door and the
numbers on the back of the remote keyless entry
transmitters.
To store your memory seat, throttle and brake pedals,
mirrors and radio presets, do the following:
1.
Adjust the driver’s seat (including the seatback
recliner, lumbar, and side wing area), throttle
and brake pedals, both of the outside mirrors, and
the radio station presets
to
your preference.
2.
Press and hold the
1
or
2
(for driver
1
or
2)
button
of the memory control for three seconds. A double
chime will sound
to
let you know that the position
has been stored.
To
repeat the procedure for a second driver, follow the
preceding steps, but press the other numbered
memory control button.
Each time button
1
or
2
is pressed and released while
the vehicle is in PARK
(P),
a single chime will sound and
the memory position will be recalled.
If you use the unlock button on the remote keyless entry
transmitter
to
enter your vehicle, the preset driver’s
seat, throttle and brake pedal, mirror positions and the
radio station presets will be recalled
if
programmed
to do
so
through the Driver Information Center (DIC).
See DIC Operation and Displays
on
page
3-47.
The numbers on the back of the transmitters,
1
or
2,
correspond
to
the numbers on the memory controls.
2-47
To Next Page
Loading...
