7-68 Infotainment System
Making a Call Using Name Tag
When the “Call” command is used,
a telephone number is entered that
has been stored in the telephone
book as a name tag.
Available commands:
.
“Yes”
.
“No”
.
“Help”
.
“Cancel”
Example of a dialogue
User: “Call.”
Voice output: “Please, say the name
tag to call.”
(for name tag information, see
“Saving a Name Tag” later in this
section)
User: ”Name tag.“
Voice output: “Seven three one.”
User: “Yes.”
Voice output: “Calling.”
Starting a Second Call
Press the button
b / g to start a
second call during an active
telephone call.
Available commands:
.
“Send”: activate manual DTMF
(touch-tone dialling), e.g. for
voice mail or telephone banking.
.
“Send name tag”: activate DTMF
(touch-tone dialling) by entering
a name tag.
.
“Dial”
.
“Call”
.
“Re-dialing”
.
“Help”
.
“Cancel”
Example of a dialogue
User: Press the
b / g button if a
telephone call is active.
User: “Send.”
Voice output: “Please, say the
number to send.”
(for number input information, see
the dialogue example for “Making a
Call Using a Telephone Number”
earlier in this section)
User: “Send.”
Re-dialing
The “Re-dialing” command re-dials
the last number dialed.
To Next Page
