10-40 Vehicle Care
License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2‑14 for more
information.
Passenger Side Shown,
Driver Side Similar
2. Push the left end of the lamp
assembly towards the right.
3. Turn the lamp assembly down to
remove from liftgate.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
4. Turn the bulb socket (A)
counterclockwise to remove from
lamp assembly (C).
5. Pull the bulb (B) straight out of
the bulb socket.
6. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install into lamp assembly.
7. Turn the lamp assembly into
the liftgate engaging the
clip side first.
8. Push on the lamp side opposite
the clip until the lamp assembly
snaps into place.
Replacement Bulbs
Exterior Lamp
Bulb
Number
Back‐up Lamp 921
Daytime
Running Lamp
7443
Fog Lamp H10
Headlamp
High-Beam
9005
Headlamp
Low-Beam
H10
License Plate Lamp 194LL
Turn Signal Front 7440
Tail/Turn
Signal Rear
7440
For replacement bulbs not listed
here, contact your dealer.
To Next Page
Loading...
