Vehicle Care 10-39
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
A. Turn Signal Lamp
B. Back-Up Bulb/Socket
6. Disconnect the wire
harness from the back-up
bulb/socket (B).
7. Turn the back-up bulb socket
counterclockwise to remove it
from the taillamp assembly.
8. Press a new bulb/socket into the
taillamp assembly and turn the
bulb/socket clockwise until it
clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.
To Next Page
Loading...
