9-36 Driving and Operating
When the stability control system
activates, the Traction Control
System (TCS)/StabiliTrak light will
flash on the instrument panel.
This also occurs when traction
control or TSC is activated. A noise
may be heard or vibration may be
felt in the brake pedal. This is
normal. Continue to steer the
vehicle in the intended direction.
If there is a problem detected
with StabiliTrak, SERVICE
STABILITRAK is displayed on the
Driver Information Center (DIC)
and
d will stay on. See Vehicle
Messages on page 5‑32. When this
message is displayed and/or
d
comes on and stays on, the vehicle
is safe to drive but the system is not
operational. Driving should be
adjusted accordingly. See Ride
Control System Messages on
page 5‑37.
If
d comes on and stays on, reset
the system by:
1. Stopping the vehicle.
2. Turning the engine off and
waiting 15 seconds.
3. Starting the engine.
If
d still comes on and stays on at
a speed above 20 km/h (13 mph),
see your dealer for service.
g is located on the console.
Both StabiliTrak and Traction
Control can be turned off if needed
by pressing and holding
g until g
and i come on the instrument
panel. This will also disable the TSC
feature. When StabiliTrak is turned
off, the system will not assist with
directional control of the vehicle or
limit wheel spin. Driving should be
adjusted accordingly. Press and
release
g again to turn the system
back on.
If cruise control is being used when
StabiliTrak activates, the cruise
control will automatically disengage.
Press the cruise control button to
re‐engage when road conditions
allow. See Cruise Control on
page 9‑37 for more information.
To Next Page
Loading...
