Vehicle Care 10-29
Up-level Vehicle
2. Locate the aim point at the
center inner projector
condensing lens of the low-beam
headlamp, not the outer lens.
3. Measure the distance from the
ground to the aim dot on the
low‐beam headlamp. Record the
distance.
4. At the wall, measure from the
ground upward (A) to the
recorded distance from
Step 3 and mark it.
5. Draw or tape a horizontal line (B)
on the wall the width of the
vehicle at the height of the mark
in Step 4.
Notice: Do not cover a headlamp
to improve beam cut-off when
aiming. Covering a headlamp may
cause excessive heat build-up
which may cause damage to the
headlamp.
6. Turn on the low-beam
headlamps and place a piece of
cardboard or equivalent in front
of the headlamp not being
adjusted. This allows only the
beam of light from the headlamp
being adjusted to be seen on the
flat surface.
To Next Page
Loading...
