10-34 Vehicle Care
Passenger Side
The removal of the air filter/cleaner
assembly and base is required
for the replacement of one of
these bulbs:
1. Open the hood. See Hood on
page 10‑5.
A. Air Duct Clamp
B. Connector Lock
C. Sensor Connectors
D. Retaining Clips
2. Disconnect the outlet duct by
loosening the air duct clamp (A).
3. Remove the connector lock (B)
located at the bottom of the
sensor connector (C).
4. Press on the top and bottom of
the sensor connectors (C) and
remove.
5. Lift the three retaining clips (D)
on the air filter housing.
6. Turn and tilt cover slightly
upwards and slide cover away
from outside edge of vehicle.
Lift the cover away from base.
7. Lift the air cleaner/filter base to
disengage from three pins.
To Next Page
Loading...
