10-36 Vehicle Care
Daytime Running Lamp (DRL)
(Up-Level)
1. From the back side of the
headlamp assembly, remove the
bottom cap to replace the
DRL bulb.
2. Disconnect electrical connector.
3. Remove the DRL bulb socket
from the headlamp assembly.
4. Replace the bulb in the bulb
socket.
5. Install the bulb socket in the
headlamp assembly.
6. Connect the electrical connector.
7. Install the cap with the down
arrow pointing down in the back
of the headlamp assembly.
8. For driver side, reinstall the
underhood electrical center
cover by latching three clips.
9. For passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat .
Verify the base is seated
securely, then install the engine
air filter/cleaner assembly.
Front Turn Signal Lamp
(Base and Up-Level)
To replace the Front Turn
Signal Lamp:
1. Remove the turn signal lamp
bulb socket from the headlamp
assembly.
2. Remove the turn signal lamp
bulb from the socket.
3. Replace the bulb in the bulb
socket.
4. Install the bulb socket in the
headlamp assembly.
5. For driver side, reinstall the
underhood electrical center
cover by latching three clips.
6. For passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat .
Verify the base is seated
securely, then install the engine
air filter/cleaner assembly.
To Next Page
Loading...
