The sealant can temporarily seal a puncture up to 6 mm
in the tread area of the tire ire. The sealant cannot
seal sidewall damage, large punctures, or a tire that
has unseated from the wheel. See Roadside Service
on page 7-7.
Using the Tire Sealant and Compressor
Kit to Temporarily Seal and Inflate a
Punctured Tire
Follow these directions closely for correct sealant
usage.
1. Do a safety check before proceeding. See If a Tire
Goes Flat on page 5-82.
2. Inspect the damaged tire.
The sealant cannot seal sidewall damage, large
punctures, or a tire that has unseated from
the wheel. See Roadside Service on page 7-7.
3. Place the tire sealant and compressor kit on the
ground and unwrap the sealant/air hose (G) from
the side of the compressor.
4. Remove the tire valve stem cap from the flat tire by
turning it counterclockwise.
5. Attach the sealant/air hose (G) onto the tire valve
stem. Turn it clockwise until it is tight.
Make sure the sealant and compressor kit On/Off
switch (D) is in the O (off) position.
6. Remove the air compressor accessory plug (C)
from the unit.
5-95
To Next Page
Loading...
