Cadillac Escalade 2021 - Page 269

Cadillac Escalade Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
13690472) - 2021 - CRC - 5/15/20
268 DRIVING AND OPERATING
hold to accelerate. If the cruise control
is already active, use to increase
vehicle speed.
SET− : Press the control down briefly
to set the speed and activate cruise
control. If the cruise control is already
active, use to decrease vehicle speed.
* : Press to disengage cruise control
without erasing the set speed from
memory.
Setting Cruise Control
If
J is on when not in use, SET− or
RES+ could get pressed and go into
cruise when not desired. Keep
J off
when cruise is not being used.
To set cruise control:
1. Press
J.
2. Get up to the desired speed.
3. Press and release SET−.
4. Remove your foot from the
accelerator.
When the cruise control has been set
to the desired speed, a green cruise
control indicator appears on the
instrument cluster and a cruise set
speed message appears on the Driver
Information Center (DIC) and
Head-Up Display (HUD), if equipped.
Resuming a Set Speed
If the cruise control is set at a desired
speed and then the brakes are applied
or
* is pressed, the cruise control is
disengaged without erasing the set
speed from memor y.
Once the vehicle speed reaches about
40 km/h (25 mph) or more, press RES+
up briefly. The vehicle returns to the
previous set speed.
Increasing Speed While Cruise
Control is at a Set Speed
If the cruise control system is already
activated:
.
Press and hold RES+ up until the
vehicle accelerates to the desired
speed, then release it.
.
To increase vehicle speed in small
increments, press RES+ up briefly to
the first detent. For each press, the
vehicle goes about 1 km/h (1 mph)
faster.
.
To increase vehicle speed in larger
increments, press RES+ up briefly to
the second detent. For each press,
the vehicle goes about 5 km/h
(5 mph) mark on the speedometer.
The speedometer reading can be
displayed in either English or metric
units. See Instrument Cluster 0 113.
The increment value used depends on
the units displayed.
Reducing Speed While Cruise
Control is at a Set Speed
If the cruise control system is already
activated:
.
Press and hold SET− down until the
desired lower speed is reached, then
release it.
.
To decrease the vehicle speed in
small increments, press SET− down
briefly. For each press, the vehicle
goes about 1 km/h (1 mph) slower.
The speedometer reading can be
displayed in either English or metric
units. See Instrument Cluster 0 113.
The increment value used depends on
the units displayed.