Calculated Industries Material Estimator - Preference Settings

P OCKET R EFERENCE G UIDE — 11
Preference Settings
Press C , then s , then keep pressing
s to toggle through the main settings.
Press the
+ key to advance within sub-set-
ting. Use the
– key to back up. Press the
o key to exit Preferences.
PRESS C AND: SETTING--FUNCTION
First press Fractional Resolution:
of
s : --1/16
+ --1/32
+ --1/64
+ --1/2
+ --1/4
+ --1/8
+ --1/16
(repeats options)
Second press Area Displays:
of
s : --Std.
+ --0.
SQ FEET
+ --0. SQ YD
+ --0. SQ M
+ --Std. (repeats options)
Third press Volume Displays:
of
s : --Std.
+ --0.
CU YD
+ --0. CU FEET
+ --0. CU M
+ --Std. (repeats options)
Fourth press Meter Linear Displays:
of
s : --0.000 M
+ --FLOAt M (floating point)
+ --0.000 M (repeats options)
Fifth press Fractional Mode:
of
s : --Std.
+ --COnSt
+ --Std.
(repeats options)