Need help?Do you have a question about the Calculated Industries MACHINIST CALC PRO and is the answer not in the manual?
General| Type | Scientific |
|---|---|
| Cover | Yes |
| Form factor | |
| Control type | Buttons |
| Product color | Black |
| Digits | 12 digits |
| Display tilting | No |
| Display size (HxV) | 15 x 65 mm |
| Display number of lines | - lines |
| Display size (HxV) (imperial) | 0.625 x 2.5 \ |
| Storage media type | - |
| Battery type | LR44 |
| Power source | Battery |
| Battery voltage | 1.5 V |
| Number of batteries supported | 2 |
Weight and Dimensions| Depth | 25 mm |
|---|---|
| Width | 90 mm |
| Height | 160 mm |
| Weight | 170 g |
Explains the various keys and their basic functions.
Describes specialized keys for machining calculations like Cutting Speed and RPM.
Explains how to input linear measurements like meters, mm, inches.
Explains how to calculate or enter RPM for milling, turning, and drilling.
Details how to calculate Feed Rate based on various inputs.
Explains how to calculate Cutting Speed based on diameter and RPM.
Describes how to calculate Feed per Tooth (Chip Load).
Explains how to determine Radial Chip Thinning factors.
Details how to calculate Cutting Feed.
How to select and view metric and U.S. drill sizes.
Calculates Drill Point Cut Depth based on drill size and angle.
Explains how to enter thread sizes and view characteristics.
Details how to find wire sizes and perform 3-wire measurements.
How to calculate bolt hole layouts, spacing, and coordinates.
Explains how to select and view U.S. drill sizes.
Details thread sizing in U.S. units, including TPI.
Details display capacity, error messages, and error codes.
To Next Page