Calculated Industries MACHINIST CALC PRO - Weight and Volume Function Keys; Trigonometric Function Keys

6 — Ma c h i n i s t ca l c ™ Pr o
(cont’d)
B
1/1000" (mils) — Multiplies a dimensionless entry
by 0.001 Inch and displays the result as Inches.
Converts a linear entry to decimal Inches. For both
methods, the result is rounded and displayed to three
decimal places
Weight and Volume Function Keys
g6
Tons — Enters or converts a weight or volume value
to tons.
g4
Pounds (lbs) — Enters or converts a weight or
volume value to pounds.
g3
Tonnes (tonne) — Enters or converts a weight or
volume value to tonnes.
g2
Grams — Enters or converts a weight or volume
value to grams.
g1
Kilograms (kg) — Enters or converts a weight or
volume value to kilograms.
g0
Weight per Volume (wt/vol) — Stores a new weight
per volume as pounds per cubic foot or other format
as shown below. Default value is 490 pounds per
cubic foot of steel.
● Pounds per cubic foot
● Pounds per cubic inch
● Tonnes per cubic meter
● Kilograms per cubic meter
Trigonometric Function Keys
g#
Sine (Sin) — Calculates the Sine of an entered
degree or unitless value.
ga
Arcsine (Sin
-1
) — Calculates the angle for the
entered or calculated Sine value.
UG4089E-A-inside.indd 6 6/9/2011 3:16:16 PM