Calculated Industries MACHINIST CALC PRO - Dimensional Function Keys

Us e r 's GU i d e — 5
Dimensional Function Keys
m
Millimeters — Identies entry as millimeters, with
repeated presses toggling between linear, area and
volume units. Converts dimensional value to units of
millimeters, with repeated presses toggling between
millimeters and meters.
g5
Centimeters (cm) — Identies entry as centimeters,
with repeated presses toggling between linear, area
and volume units.
g9
Meters (m) — Identies entry as meters, with
repeated presses toggling between linear, area and
volume units.
g7
Feet — Identies entry as Feet, with repeated
presses of
g 7
toggling between linear, area and
volume units. Also used with
i
and
/
for entering
Feet-Inch values. Repeated presses of
g 7
during
conversions toggle between fractional Feet-Inch and
decimal Feet.
i
Inch — Identies entry as Inches, with repeated
presses toggling between linear, area and volume
units. Entry can be whole or decimal numbers. Also
used with
/
for entering fractional Inch values (e.g.,
9i1/2
). Repeated presses during conversions
toggle between fractional and decimal Inches.
/
Fraction Bar — Used to enter fractions. Fractions
can be entered as proper (1/2, 1/8, 1/16) or improper
(3/2, 9/8). If the denominator (bottom) is not
entered, the calculator’s fractional accuracy setting
is automatically used. Results are always shown in
typical dimensional fractional format.
(cont’d)
UG4089E-A-inside.indd 5 6/9/2011 3:16:16 PM