Calculated Industries MACHINIST CALC PRO - Appendix B - DEFAULT SETTINGS

52 — Ma c h i n i s t ca l c ™ Pr o
APPENDIX B – DEFAULT SETTINGS
After a Clear All (
g *
), your calculator will return to the
following settings:
STORED VALUES DEFAULT VALUE
Number of Teeth 1.
Drill Point Angle 118°
Weight per Volume 490 pounds per cubic foot
% Thread 75%
Thread Classication
Metric Threads Internal 6H
U.S. Threads Internal 2B
If you replace your batteries or perform a Full Reset* (press
o
,
hold down
*
and press
O
) your calculator will return to the
following settings (in addition to those listed above):
PREFERENCE SETTINGS DEFAULT VALUE
Fractional Resolution 1/64 "
Functional Result Rounding 0.0000
Default Unit Format Metric
Area Answer Format Standard
Volume Answer Format Standard
Fractional Mode Standard
Mathematical Operation Order of Operations Method
* Depressing the Reset button located above the
C
key will also perform
a Full Reset.
UG4089E-A-inside.indd 52 6/9/2011 3:16:19 PM