Us e r 's GU i d e — 53
APPENDIX C – PREFERENCE SETTINGS
The Machinist Calc Pro has Preference Settings that allow you
to customize or set desired unit formats and calculations. If
you replace your batteries or perform a Full Reset* (press
o
,
hold down
*
, and press
O
), your calculator will return to the
following settings (in addition to those listed on the previous
page), with the default setting for each preference listed rst:
* Depressing the Reset button located above the
C
key will also perform
a Full Reset.
PREFERENCE OPTIONS
1) Fractional
Resolution
– 1/64: displays fractional values to the nearest
64th of an Inch.
– 1/2: displays fractional values to the nearest
half Inch.
– 1/4: displays fractional values to the nearest
quarter of an Inch.
– 1/8: displays fractional values to the nearest
8th of an Inch.
– 1/16: displays fractional values to the nearest
16th of an Inch.
– 1/32: displays fractional values to the nearest
32nd of an Inch.
2) Functional
Result
Rounding
– 0.0000: calculation results using Machinist
functions are displayed to four decimal
places.
– 0.000: calculation results using Machinist
functions are displayed to three decimal
places.
– FLOAT: calculation results using Machinist
functions are always displayed to the
maximum number of decimal places.
(cont’d)
To Next Page
Loading...
