10 — Ma c h i n i s t ca l c ™ Pr o
(cont’d)
D
Drill Size — Enters a metric, numeric, letter or
fractional Drill Size, displaying the millimeter (Metric
mode) or decimal Inch (U.S. mode) equivalent of
the Drill Size. The next smaller Drill Size is displayed
if the entered value doesn’t match a Drill Size.
Repeated presses of
D
or
+
toggle through Drill
Sizes in increasing order. Presses of
-
toggle through
Drill Sizes in decreasing order. Selected Drill Size is
stored upon exiting function.
gD
Drill Point — Enters the Cutting Angle of a Drill
Point. Calculates the Drill Point Cut Depth that
needs to be taken into account when it’s necessary
to maintain a specic full diameter depth.
#
Number of Teeth — Enters the Number of Teeth on
a tool. Default value is 1.
F
Feed per Tooth — Enters or calculates Feed
per Tooth (Chip Load). Unitless entries assumed
millimeters in Metric mode; Inches in U.S. mode.
Calculates Feed per Tooth given entered Cutting
Feed and Number of Teeth or RPM (Spindle Speed),
Feed Rate and Number of Teeth.
c
Cutting Feed — Enters or calculates Cutting Feed.
Unitless entries assumed millimeters per revolution
in Metric mode; inches per revolution in U.S. mode.
Calculates Cutting Feed given entered Feed per
Tooth (Chip Load) and Number of Teeth or Feed
Rate and RPM (Spindle Speed).
d
Diameter — Enters a Diameter. Unitless entries
assumed millimeters in Metric mode; Inches in U.S.
mode. Calculates circle Area and Circumference
given entered Diameter. Calculates Diameter given
entered Radius.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
