Us e r 's GU i d e — 11
gd
Radius — Enters or calculates a Radius. Unitless
entries assumed millimeters in Metric mode;
Inches in U.S. mode. Calculates Radius given
entered Diameter.
g8
Alpha — Enters alphabet character selection mode.
While in this mode, a letter can be selected and
used with
D
to enter a letter Drill Size. Entering
this mode with a unitless entry between 1 and 26
will display the corresponding letter of the alphabet
(i.e.
5g8
displays the letter E). While in Alpha
mode, presses of
8
or
+
toggle forward through the
alphabet, while presses of
-
toggle backward.
a
Adjacent — Enters or calculates the Adjacent
(horizontal) leg of a right triangle. Calculates
Adjacent value given two other right-triangle
values. Also enters the Center x-coordinate of a
Bolt Pattern.
p
Opposite — Enters or calculates the Opposite
(vertical) leg or height of a right triangle. Calculates
Opposite value given two other right-triangle values.
Also enters the Center y-coordinate of a Bolt Pattern.
h
Hypotenuse — Enters or calculates the Hypotenuse
(diagonal) of a right triangle. Calculates Hypotenuse
value given two other right-triangle values.
n
Angle — Enters or calculates an Angle, providing
the Adjacent Angle for both instances. Calculates
an Angle given two other right-triangle values. Also
enters the Starting Angle of the rst hole of a Bolt
Pattern, with 0° being the three o’clock position and
the rotation going counterclockwise.
To Next Page
Loading...
