— 6 —
3. From the GigaCenter’s Embedded Web Interface (EWI), complete the following
three steps included in the online Quick Start menu:
a. Connect to Internet
b. Confi gure Wireless Network (2.4 GHz and 5 GHz)
c. Set Time Zone (set to local time)
4. Click apply upon completion.
5. Check the Connection under the EWI’s Status menu. The Service LED should
be on (solid green). Refer to the LED Status indicator section below for trouble-
shooting unexpected behavior.
LED Status Indicators
Power - If solid GREEN, unit is powered up and operational. If solid AMBER or RED,
please contact your service provider. If fl ashing AMBER, device is undergoing a soft-
ware update - do not power off if in this state.
Broadband - If solid GREEN, a broadband connection has been established.
Service - If solid GREEN, Internet service has been established. If solid AMBER ,
the device is in “Walled Garden” mode (your browser may be redirected to a service
provider’s website). If solid RED, the device has failed to receive an IP address or a
PPPoE session has not been established.
WiFi 2.4 GHz, WiFi 5 GHz, Ethernet 1-4, Phone 1-2, USB - If solid GREEN or fl ash-
ing GREEN, services are provisioned or devices are connected and active.
Status Quick Start Wireless Utilities Advanced
Home Logon AboutHelp
Getting Started with Home Gateway Settings
1. With the 844E GigaCenter connected to your PC, open a browser and enter the
following URL into the address bar and then press enter:
http://192.168.1.1
2. At the login prompt, enter the User Name and Password provided on the 844E
label shipped inside the shipping carton (also affi xed to the GigaCenter itself).
To Next Page
Loading...