Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Introduction
This document describes the installation of the following:
GigaSpire BLAST u6.2
GigaSpire BLAST u6.1
GigaSpire BLAST u6.x
GigaSpire BLAST u12
GigaSpire BLAST u12x
All BLAST units above are designed to be placed in a horizontal table-top configuration or
can be wall mounted using the optional wall mount bracket.
Powering Options
By attaching to any 110/220 VAC power outlet using the supplied 12 VDC wall
transformer.
For the BLAST u6.1, u6.2, and u6.x, a UPS may be used. In this configuration, UPS
with alarm telemetry and an 8-pin connector on the GigaSpire attaches to an 8-pin
connector on the UPS.
Note: For all models, the power cord configuration must be appropriate for use in the
country where the device is being deployed.
Note: Only Calix provided and approved power cords or voltage adapters should be
used to connect to this product(s).
To Next Page
Loading...
