Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
If no device is found after the initial 120
second time-out, the WPS/Strength
LED bar shifts from blinking green to
solid red.
LED bar remains red for another 60
seconds, then reverts to the "No
Internet failure status.
If pairing is accomplished, LED bar
changes to reflect gateway status.
6. After pairing,
monitor
gateway status
After pairing is complete (60 seconds
after the signal strength has been
displayed), the light bar indicates the
gateway status as being on-line.
If the Mesh is connected via WIRED
Ethernet and if boot-up was successful,
the light bar indicates the actual
gateway status (top LED is lit). Refer to
LED Stats - GigaSpire Turn-up (on
page 32) for additional information
To Next Page
Loading...
