Setting up your second GigaSpire BLAST u6 (as a satellite)
Using wireless backhaul
1
Connect the GigaSpire BLAST
u6 to a power outlet.
2
3s
When the LED is red on the
second BLAST u6, you can begin
pairing it with the first BLAST u6.
Press and hold the WPS button
on the first BLAST u6 system for
3 seconds, then on the second
BLAST u6 system for 3 seconds
(less than 30 seconds apart).
Set up your Calix CommandIQ App
(see page 9 for details).
3
Note: The LED on both of the BLAST
u6 systems will flash GREEN when
pairing for wireless backhaul.
3s
Note: Once pairing is successfully
complete, both BLAST u6 systems will
show a solid blue light (this may take
several minutes). You can then move
to step 3.
Otherwise, re-attempt until pairing is
successful.
To Next Page
Loading...
