22
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Tabletop Mounting the BLAST u6me
Any Calix GigaSpire BLAST u6me can be mounted flat on a tabletop. Four (4) rubberized
feet are pre-installed on the bottom of the unit to provide a non-skid surface when placing
the unit on a table or shelf.
Keep the following information in mind when considering tabletop mounting:
Due to component placement inside the chassis, do not remove the rubber feet that are
installed on the bottom of the unit. Locate the device on the desktop in a location that is
unlikely to be bumped or jostled.
Make sure that the Ethernet cable[s] (if used) and power supply wiring attached to the
GigaSpire are secured properly and out of harms way.
Note: Once the unit is connected and turned up, Wi-Fi network parameters are persisted
in memory. For this reason, if power is lost to the device, it will be re-discovered on the
network automatically, without operator intervention.
To Next Page
Loading...
