Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Chapter 3
Final Set-up and Testing
BLAST u4/u4m Reset Behavior
Calix EDGE systems support a variety of system reset functions and provide multiple
methods for invoking each of these functions, as described in this topic. Calix defines these
functions and behaviors as follows:
1. Basic reset (reboot): Restarts the unit.
2. Configuration reset: Resets the RG configuration settings (those visible to the
subscriber/Admin user in the EWI, such as SSIDs, LAN IP scope, etc.) to defaults, but
retains operator-configured management settings (those visible only to the Support user
in the EWI, such as ACS URL and SPID).
3. Factory reset: Resets the router (and any attached mesh satellites) to factory default
settings. A factory reset also removes devices from network management systems such as
Calix Support Cloud and the Smart Home Admin Dashboard, where applicable.
To Next Page
Loading...
