EasyManua.ls Logo

CalMag CalSoft Mini - Installation

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CALSOFT
MINI
CALSOFT
MIDI
CALSOFT
MAXI
Fits under a sink YES NO NO
Parts guarantee 5yr 5yr 5yr
Metered YES YES YES
No of people 1-8 1-11 1-15
Capacity per regeneration @300ppm 2000 litres 3000 litres 4000 litres
All domestic situations YES YES YES
Salt used per regen (approx) 2kg 2.8kg 3.5kg
Water used per regen (approx) 85 litres 115 litres 202 litres
Preferred salt used Tablet Tablet Tablet
Installation kit included YES YES YES
Water hardness test kit included YES YES YES
Extended warranty available YES YES YES
Max ow rate l/min with 15mm kit 50 50 50
Max ow rate l/min with 22mm kit 70 70 70
Max pressure recommended 5 bar 5 bar 5 bar
Salt storage capacity 15kg 25kg 35kg
Inlet/Outlet
3/4” BSP or
1” BSP
3/4” BSP or
1” BSP
3/4” BSP or
1” BSP
Valve Display
Your CalSoft unit has been pre-programmed for a water hardness level of 300ppm. Under normal
operating conditions these settings do not require any adjustment but if they are required to be
adjusted please contact your installer or Calmag.
If the electricity fails, the electronic controller will keep in the memory the pre-set program.
Use the up and down arrows to set the correct time of day.
If you need to manually initiate a regeneration, please see section “PROGRAMMING” in the manual.
Operating Tips
Keep the bypass closed at all times.
Open the bypass to service the water softener
and to allow hard water to service.
Keep the salt level at all times above the
water in the brine tank.
Installation
Water pressure
A minimum of 1.5 bar inlet water pressure is required for the valve to operate effectively.
Do not exceed 5 bar. If the pressure is higher t a pressure reducing valve. Note:- It is recommended
that a pressure reducing valve rated at 5 bar should be tted on the valve inlet.
Electrical connection
A standard UK power supply is required to operate the unit.
Bypass
Always provide a bypass valve for the installation.
Water temperature
Water temperature is not to exceed 43°C. The unit cannot be subjected to freezing conditions.
Both will invalidate any guarantees.
- 5 -
CalSoft Mini, Midi & Maxi
2. Installation guidelines

Related product manuals