EasyManua.ls Logo

Caloric CST 6003 - Display and Features

Caloric CST 6003
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
TIMER
CLOCK
+
+
MINS
HRS MINS
OVEN LIGHT
SURFACE
HRS
Display and Features
Item Description
TIMER Pad Selects timer feature. Timer can be set up to 11 hours, 59 minutes. Timer does not control
oven operation.
TIMER
pad has light that flashes when timer is being set and glows when timer is counting
down. Timer light allows user to identify timer mode quickly and easily.
CLOCK Pad Pad is pressed to set clock and turn clock display on and off.
HRS Pad Pads increase or decrease time by hours.
MIN Pad Pads increase or decrease time by minutes.
Temperature knob Controls oven temperature, self-clean, and broil. Push-to-turn knob prevents accidentally
turning oven on.
OVEN light
Glows when oven is on. Light flashes after self-clean cycle turns off as a reminder to turn
temperature knob to
OFF
.
LOCKED light
Glows when oven door is locked and oven is set for self-cleaning. After self-clean cycle,
light flashes. Unlatch oven door and turn temperature knob to
OFF
.
PREHEATED light Glows when oven reaches selected temperature.
Time display Shows the time-of-day and timer minutes. Will not display
AM
,
PM
, or military time.
Other Features
12-hour automatic
cancel
This safety feature prevents oven from continuing to heat if it has been left on for over 12
hours. This feature can be turned on or off while the temperature knob is in OFF position.
To operate oven for more than 12 hours press and hold the MINS+ and – pads for
approximately 4 seconds. Display will change from time-of-day to show ‘OFF’ and then
return to time display.
To set oven to shut off after 12 hours press and hold the MINS + and – pads for
approximately 4 seconds. Display will change from time-of-day to show ‘ON’ and then
return to time display.
Service codes
and tones
Range control is equipped with a self-diagnostic system. This alerts you if there is an error
or problem in the control. If electronic range conrol sounds a series of short, rapid beeps
for over 16 seconds and display shows an F-code, disconnect electrical supply to range
and contact an authorized servicer.
F2—High oven temperature
F3—Temperature sensor
F4—Temperature sensor
FFF—Control failure