Fasten your Cambox
The Velcro fastener gluing needs to be done in a temperate and non moist
atmosphere (approximately 15°C) to ensure maximum grip of the glue. It is also
recommended to wait at least 4 hours before placing the Cambox on its clean and
dry support !
It is advised to wait at least 4h after gluing before fixing your Cambox
Prior to gluing, it is recommended to
place the fastener under your visor
in order to memorize its future
position.
Remove meticulously the paper
protection of the velcro in such a
way that your fingers do not touch
the adhesive part.
Place the velcro fastener under the
visor and press strongly on all the
surface to ensure a good bonding.
Present the Cambox horizontally in front
of its velcro support.
Apply a pressure on the 3 parts of the
Cambox as depicted
12
To Next Page
Loading...
