To Next PageTo Next Page
Need help?Do you have a question about the Cambridge Air Solutions S Series and is the answer not in the manual?
General| Brand | Cambridge Air Solutions |
|---|---|
| Model | S Series |
| Category | Heater |
| Language | English |
Explains the meaning of warning and caution symbols used in the manual.
Identifies and labels various accessories used with the heater system.
Illustrates and labels the different parts and configuration of the heater unit.
Covers unpacking procedures and site selection for heater installation.
Details the specific steps for mounting the heater on a roof.
Outlines the steps for installing the heater through a wall.
Provides specific instructions for mounting the heater under a roof.
Details the installation process for vertically mounting the heater indoors.
Outlines the steps for installing the heater vertically outdoors.
Details the installation of the structural inlet elbow accessory.
Details the installation of the adjustable stand accessory.
Instructions for installing the structural filter section accessory.
Installation details for the downturn with lugs accessory.
Instructions for installing the horizontal mounting stand.
Instructions for installing the vertical inlet skirt accessory.
Details the installation of the rain hood inlet skirt accessory.
Sequential steps for initial start-up of the heater unit.
Instructions for adjusting the burner manifold pressure.
Steps to verify and perform calibration checks on the control system.
Procedures for checking gas train and gas valve for leaks.
Final checks and preparation steps before operating the heater.
Specific calibration steps for EDL control systems.
Calibration procedures for EDSM and EDSM/TP control systems.
Calibration steps for EDR control systems.
Describes the sequence of operations for the heater.
Details the features and operation of the electronic thermostat.
Setting thermostat temperatures and performing calibration.
Details on the features and programming of the TSS controller.
Instructions for setting time, date, and DST on the TSS controller.
Setting the ON time schedule for heating mode.
Setting the OFF time schedule and using the override timer.
Information on the BACnet controller for BAS integration.
Settings for network parameters like address and baud rate.
Describes operating sequences for Unit Heater, Makeup Air, Ventilation, and Unoccupied modes.
A structured guide to diagnose and resolve operational issues.
Guidelines for lubricating blower and motor bearings.
Information on filter types, cleaning, and replacement.
Tasks for belt tension, blower cleaning, and burner cleaning.
Procedure for cleaning the gas valves.
Detailed problem/solution table for diagnosing issues.
Steps for replacing and adjusting the damper motor.
Layout diagram of the electrical control enclosure.
System wiring schematics for the heater.
Diagrams illustrating various gas train configurations.
Descriptions of remote control stations and their components.
Descriptions of gas control systems like EDL, EDR, EDSM.
Descriptions of key heater components like airflow switch and damper motor.
Description and installation details for the thermistor sensor.
Standard's purpose, requirements, and compliance for heaters.
