What to do if Cambridge Air Solutions Heater indicates a device fault?
If the Fault LED is on steady, it means a main code download is required. This could be because no application is loaded, the controller is in boot mode and needs a main code download, or there's a firmware mismatch between the PEAK controllers and the ZRF1811 Wireless Field Bus Router. In any of these cases, performing a main code download is the suggested solution.
What to do if Cambridge Air Solutions Heater loses power but is still connected?
If your Cambridge Air Solutions Heater is connected to power but remains off, you should check the output wiring for short circuits and then cycle power to the controller.
Presents important warnings and cautions for safe installation and operation.
Details for roof top, stand mount, and thru-wall installations.
Instructions for outdoor and indoor vertical mounting.
Guidance on proper gas piping and electrical wiring for installation.
Checks for physical damage, wiring, and supply voltage/pressure.
Procedures for checking blower rotation, pressure drops, and manifold pressure.
General| Brand | Cambridge Air Solutions |
|---|---|
| Model | M125 |
| Category | Heater |
| Language | English |
To Next Page