To Next PageTo Next PageWhat to do if Cambridge Air Solutions Heater indicates a device fault?
If the Fault LED is on steady, it means a main code download is required. This could be because no application is loaded, the controller is in boot mode and needs a main code download, or there's a firmware mismatch between the PEAK controllers and the ZRF1811 Wireless Field Bus Router. In any of these cases, performing a main code download is the suggested solution.
What to do if Cambridge Air Solutions Heater loses power but is still connected?
If your Cambridge Air Solutions Heater is connected to power but remains off, you should check the output wiring for short circuits and then cycle power to the controller.
Critical safety warning indicating risk of death or serious injury.
Guidance on selecting a suitable installation location for the heater.
Steps for rooftop installation, including safety and preparation requirements.
Steps for through-wall installation, including safety and preparation.
Steps for outdoor vertical mount installation, including safety considerations.
Covers gas supply requirements, sizing, installation, and leak testing procedures.
General| Brand | Cambridge Air Solutions |
|---|---|
| Model | M120 |
| Category | Heater |
| Language | English |
