What to do if Cambridge Air Solutions Heater indicates a device fault?
If the Fault LED is on steady, it means a main code download is required. This could be because no application is loaded, the controller is in boot mode and needs a main code download, or there's a firmware mismatch between the PEAK controllers and the ZRF1811 Wireless Field Bus Router. In any of these cases, performing a main code download is the suggested solution.
What to do if Cambridge Air Solutions Heater loses power but is still connected?
If your Cambridge Air Solutions Heater is connected to power but remains off, you should check the output wiring for short circuits and then cycle power to the controller.
Details important safety warnings regarding modifications, personnel, and airflow.
Covers essential installation steps for gas piping and electrical wiring.
Addresses problems related to no blower operation or blower running with no heat.
Covers troubleshooting for burner not firing or flame safeguard relay lockouts.
Solutions for tripped high limits and units that won't cycle off.
Troubleshooting for modulating valve problems and erratic flames.
General| Input Capacity | 1, 350, 000 BTU/hr |
|---|---|
| Airflow | 13, 600 CFM |
| Phase | 3 |
| Number of Heating Stages | 2 |
| Mounting | Suspended |
To Next Page