PROGPROG
PROG
PROG
>3 s
<6 s
>3 s
VA/01
MTMA/01
MTMV/01
beep
Page 3 - Manual FA01031-IT - 08/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Page 3 - Manual FA01405-EN - 10/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructionsPage 3 - Manual FA01405-EN - 10/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructions
Press the door-release and AUX2
keys and enter the group call code
(from 1 to 98) followed by key : The
call code is associated with the internal
receiver and the call key chosen .
Continue, repeating the same opera-
tions for all the other internal receivers.
The operation can only be carried out
from an entry panel with the
LED o .
? To change the entry panel from
which to carry out call programming,
you must press key 1 followed by key
.
Programming the call codes
The LED will fl ash to signal entry into programming .
With VA/01
Press the PROG key until the PROG LED
lights up .
With MTMA/01-MTMV/01 with-
out VA/01
Press the PROG key for at least 3 sec-
onds and release it within 6 seconds .
PROGRAMMING CALL CODES AND DOOR-RELEASE CODES
? This programming is available only with audio modules MTMA/01 and video modules MTMV/01.
Call programming associates a call code with each internal receiver.
Programming the door-release codes associates number codes with the relays present on audio module MTMA/01 or video
module MTMV/01. The control is local and where there is more than one audio module MTMA/01 and video module MTMV/01
carry out the door-release programming on each entry panel.
Going into Programming
To Next Page
Loading...
