Page 20 - Manual FA01639-EN - 12/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
On the internal receiver, press the INTERCOM button with which you wish
to associate it.
Wait for the beep that will confi rm successful programming.
Repeat for all the internal receivers you wish to include in the
intercommunicating group.
Exiting programming mode
To exit programming mode, press the [PROG] button. All LEDs except the button LEDs will switch o .
Reprogramming a system
In an already programmed system, pressing the [PROG] button takes you directly to the [Programming calls] phase.
You do not need to perform [Programming call buttons] again.
To force [Programming call buttons] again, press and hold the [PROG] button for at least 3 seconds and no
longer than 6.
You will need to run [Associate internal receivers] and [Program OPEN GATE and GATE STATUS function] again
To Next Page
Loading...
Need help?
General
