Page 27 - Manual FA01639-EN - 12/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
M1
At the end of the saving process, remove the PROG RFID jumper and put
it to one side.
Deleting tags/cards
You can delete all cards or tags for a single group/button.
M1
Insert the power supply unit RFID PROG jumper in the “-” position.
and the PROG LEDs will fl ash slowly.
If the LEDs suddenly switch o , this means there is a problem with the connection between the power supply
unit and the entry panel. Check the connections and return to programming mode.
To Next Page
Loading...
