Need help?Do you have a question about the CAME BPT THANGRAM and is the answer not in the manual?
General| Operating Temperature | -25°C to +55°C |
|---|---|
| Housing Material | ABS Plastic |
| Ingress Protection Rating | IP54 |
| Audio Frequency Response | 300Hz - 3.4kHz |
| Speaker Output | 1 W |
| Type | Video Intercom |
| Mounting | Surface Mount |
| Wiring | 2-wire |
| Microphone Sensitivity | -42dB ±3dB |
Details power supply, audio, data, and video connections.
Details solenoid lock, door release, data, and ground connections.
Describes the programming key and its associated LED states.
Covers audio settings and solenoid lock timing adjustments.
Configures video line distance using DIP-1 switch.
Configures data line distance using DIP-2 and DIP-3 switches.
Details power supply, current absorption, and standby consumption.
Specifies operating and storage temperatures, and IP rating.
Lists camera standard, resolution, and minimum lighting.
Explains how to program multiple panels with identical call assignments.
Details programming panels with varied key types using a specific sequence.
Highlights limitations when programming different key types and mentions PC software.
Steps to enter the programming mode via the PROG key.
How to select the key type and assign an address to the entry panel.
Associating call buttons with internal extensions using specific keys.
Procedures for safely exiting the programming mode.
Adjusting the camera's visual field during call button programming.
Steps to enter programming mode for multiple entry panels.
How to set the key type for each entry panel in a multi-panel setup.
Associating call keys with internal extensions for multiple panels.
Procedures for exiting programming mode after multi-panel setup.
Adjusting the camera's visual field during call button programming.
Steps to access the reprogramming mode.
How to reprogram existing call key associations.
Steps to exit the reprogramming mode.
How to reprogram the key type on entry panels.
Adjusting the camera's visual field during reprogramming.
Steps to access programming mode for DNA configurations.
Assigning specific call codes for DNA entry panels.
Procedures for exiting programming mode.
Instructions for adding RFID badges or tags.
Instructions for entering access codes.
Instructions for deleting RFID badges or tags for a group.
Instructions for deleting access codes for a group.
How to cancel all codes and badges for a specific group.
How to cancel codes for DNA entry panels.
To Next Page
