M1
M2
CN2
PROG
DAT I
A
A
D
V
MINI
USB
CN4
SW2
1
B
3
4
5
8
9
G
J
6
Page 2 - Manual FB00864-EN - ver. 1 - 08/2017 - © CAME S.p.A. - The contents of this manual are subject to change at any time without prior notice.
General warnings
Important personal safety instructions: READ CAREFULLY!
• Installation, programming, commissioning and maintenance must only be performed by qualified and experienced
personnel in compliance with applicable regulations.
• Wear antistatic shoes and clothing if working on the control board.
• Keep hold of these warnings.
• Always disconnect the power supply during cleaning or maintenance.
• This product should only be used for the purpose for which it was explicitly designed. Any other use is considered
dangerous.
• The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable use.
Features
Terminal board A
+
Power supply 14-18 VDC
–
A
Audio
A
+
Data line
D
–
+
Video signal
V
–
Attention. For the manual programming of the entry panels,
the self-connection order is V1-V2-V3-V4.
Terminal board B
Solenoid lock
12 V - 1 A max
–
Door lock release button (NA)
Data line
– Ground
Entry panel enabling output (active towards earth)
– Ground
PROG key C and PROG LED 4
Programming key and LED (see 'Programming' paragraph).
The PROG LED can take on the following states:
O
On
Slow flashing
Quick flashing
Adjustments 5
loudspeaker audio
microphone audio
solenoid lock 1-10 s. (default 1 s)
To Next Page
Loading...
