CAME S.p.A.
Via Martiri Della Libertà, 15
31030 Dosson di Casier - Treviso - Italy
tel. (+39) 0422 4940 - fax. (+39) 0422 4941
>10’’
>1’’
beep
beep
12345
12345
beep
beep
+
+
PROG
PROG
+
Ð
F
G
H
I
J
Englis h - Manual FB00864-EN - vers. 1 -08/2017 - © Came S.p.A. - The contents of the manual are to be considered as subject to change at any time and without the need for any advance warning.
Badges and Codes. Entry panel with buttons: press the call key for at least 10
seconds F relative to the GROUP for which you want to cancel the codes and, after
the beep, press the key (briefly) a second time G. This will delete ALL codes and
badges of any type of the GROUP.
Entry panels with DNA. Enter the call code followed by the key 8 relative to
the GROUP for which you want to cancel the codes and, after the beep, enter the
call code again followed by the key 9. This will delete ALL codes of any type of
the GROUP.
At the end, return the RFID PROG jumper to its standby position J: the proce-
dure will NOT end automatically!
The product complies with the applicable reference directives.
Dismantling and disposal. Dispose of the packaging and the device properly at the end of its life cycle, according to the regulations in
force in the country where the product is used. The recyclable components bear the symbol and code for the material.
THE DATA AND INFORMATION PROVIDED IN THIS MANUAL ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT PRIOR NOTICE. MEASUREMENTS, UNLESS
OTHERWISE INDICATED, ARE IN MILLIMETRES.
To Next Page
Loading...
Need help?
General
