3 sec
... beep!
Page 11 - Manual FA 01622- EN - 08/2022 - © CAME S.p.A. -The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Door status function
The LED next to this button indicates the
current door status.
☞The system must be correctly set up.
☞The function is active during the steps
that involve communicating with the entry
panel and the signal refers to the entrance
associated with the entry panel.
Automatic door-release function
This function allows you to automatically
open the entrance when you press the call
button on the entry panel.
This function is useful for professional
practices.
Press and hold this button for more than
3 seconds to enable/disable the function.
☞The LED switches on to indicate that
the function has been enabled.
☞The call ends automatically.
Configuring melodies
☞ Perform each of the following programming steps, in succession:
Entering programming mode
Press and hold the button for 3 seconds.
A short buzzing sound and a red fl ashing
LED confi rm that you have entered
programming mode.
To Next Page
Loading...
Need help?
General
