Need help?Do you have a question about the CAME PLX V and is the answer not in the manual?
Activates/deactivates communication and sends a PANIC SIGNAL to the porter.
Activates entry panel selection and controls the AUTOMATIC DOOR RELEASE function.
Adjusts ringtone volume and audio volume during calls.
Used for Auxiliary 2 functions or to signal a request to be called back.
Sends DOOR RELEASE or GATE RELEASE commands, with a long press for GATE RELEASE.
Buttons configurable as INTERCOM (1-6) or AUX (1-5) based on installation.
Opens menu to set display parameters with active video.
Guides through answering calls, activating communication, and ending calls.
Press button to activate video communication with the entry panel.
Press button multiple times to display multiple entry panels sequentially.
Explains video activation on MASTER receivers during simultaneous calls.
Press button to display video on a SLAVE receiver.
Press button to initiate audio communication with the entry panel.
Press button to select the desired internal receiver for communication.
Press button on called receiver to activate audio communication.
Press AUX button to activate auxiliary commands like light or gate opening.
Select internal receiver to transfer an active call.
Manage calls between internal receivers and entry panel.
Indicates porter wishes to be called back via LED.
Send a call request signal to the porter.
Press and hold button for 2 seconds to send a PANIC signal to the porter.
Porter receives signal and acoustic alarm for activated alarm contact.
Press and hold button to send open/close command, LED indicates operator status.
LED next to button indicates current door status.
Press and hold button to enable/disable automatic door release function.
Press and hold button for 3 seconds to enter programming mode.
Listen to and select melodies for calls from the entry panel.
Listen to and select melodies for calls from the landing.
Set the number of rings per call (1 to 12).
Adjust brightness, contrast, and color of the display.
Product compliance with applicable standards, including FCC rules.
Instructions for cleaning the device using damp cloths and mild solutions.
Guidance on responsible disposal of packaging and the device.
To Next Page
General
