CAML-TOMLIN FLOW48-2W - Install Return Panel Wall Jamb (Continued)

Using a 1/4” drill bit, drill four holes into your wall through the centre marks drawn earlier. Use a bit appropriate to your wall
finish.
Insert the plastic wall anchors (18) into the holes and mount the wall jamb and wall jamb extension. using the provided
screws (20).
14.
17www.camltomlin.comFLOW INSTALLATION - CORNER
A
B
Install return panel wall jamb (continued)
A
x4
1/4”
A B
A
B
x4
18
20
26