15
7. Electrical/Pneumatic circuit
8. Product storage and transport
• Adopt all measures possible to avoid accidental damage to the product during transport, and
when available use the original packaging.
• Observe the specified storage temperature range of -20 ÷ 70 °C.
9. Installation and start-up
• During unpacking, take great care not to damage the product.
• Check whether there are any faults caused by product transport or storage.
• Separate all packaging material to enable the recovery or disposal in accordance with current
standards in the country of use.
• Where possible avoid the risk of repeated pressure surges on the circuit where the
component is installed.
• The components must be fixed correctly using, where possible, the specific anchors and
ensuring that the fixture remains efficient even when the actuator is repeatedly used at a
high frequency and in the presence of strong vibrations.
• Once the component is installed, ensure that all air ways are securely connected to the
respective couplings.
• If the power supply is turned off, residual pressure may remain on the secondary side of the
regulators. The manufacturer must provide for additional exhaust components.
Recommended pneumatic circuit
• Keep the protective cap of the M12 connector until the regulator is completely installed.
To Next Page
Loading...