Operation and maintenance instructions
Series PME proportional pressure regulator
24
11.2.4. PASSWORD
By pressing the "Set new password" button you can enter a new password (up to 4 alphanumeric
characters) which will be saved in the device memory. If you forget the customized password, it will
no longer be possible to modify the regulator parameters (in this case, contact the Camozzi Service
to reset the regulator password to the factory settings). The password is not required to view the
parameters.
11.2.5. SAVING PARAMETERS
All modified parameters (including the password) are saved in the regulator memory by pressing
the “Write new parameters” button. The procedure requires entering the regulator password. The
factory password is “0000”.
12. Use
• Ensure that the pressure in the compressed air supply system and all other operating
conditions remain within the admissible values.
• Use with liquids or gas is not permitted according to the intended use
• The LED bar on the regulator provides information regarding the status of the product,
please refer to the table below.
Regulator is working with no errors or warnings.
The regulator has registered an ERROR. Pressure regulation is interrupted.
ALARM_INTERNAL: an internal component of regulator don’t work properly.
ALARM_PRESSURE: il regolatore non è riuscito a raggiungere la pressione target.
The regulator has registered a WARNING. Pressure regulation is not interrupted.
WARNING_INTERNAL: an internal component of regulator don’t work properly
WARNING _PRESSURE: The regulator is not able to reach the target pressure.
WARNING_ANALOG_SIGNAL: The analog target signal is out of range..
WARNING_UNDERVOLTAGE: Power supply is below the minimum value
Regulator is working with no errors or warnings.
The regulator has registered an ERROR. Pressure
regulation is INTERRUPTED.
The regulator has registered a WARNING. Pressure
regulation is not interrupted.
Wireless board is available and the regulator is
connected to the supervisor software UVIX
Wireless board is available but the regulator is not
connected to the supervisor software UVIX
Wireless board is not available
Regulator is working with no errors or warnings.
The regulator has registered an ERROR. Pressure
regulation is INTERRUPTED.
The regulator has registered a WARNING. Pressure
regulation is not interrupted.
Wireless board is available and the regulator is
connected to the supervisor software UVIX
Wireless board is available but the regulator is not
connected to the supervisor software UVIX
Wireless board is not available
To Next Page
Loading...
