Campbell CR300 series - Install the SIM Card; Konect Pakbus Router Setup; Get Started

3.1.2 Install the SIM card
1. Remove the SIM card cover.
2. Note the location of the notched corner for correct alignment. The gold contact points of
the SIM face down when inserting the SIM card as shown in the following figure. Gently
slide the card into the slot until it stops and locks into place. To eject the SIM card, press it
in slightly and release.
3. Replace the SIM card cover.
Figure 3-1. SIM card installation
3.1.3 Konect PakBus Router setup
3.1.3.1 Get started
You will need the Konect PakBus Router redemption code that came on a card with the CR300-
CELL series.
Open a web browser and go to www.konectgds.com .
3. Cellular communications option6