CR300-Series Datalogger
5
The CR300 does not use a security
code or a PakBus encryption key by
default, so the Security Code can be
set to 0 and the PakBus Encryption
Key can be left blank. If either
setting has been changed, enter the
new code or key. Security can be set
through Device Configuration
Utility, Connect Screen Settings
Editor, or the SetSecurity()
CRBasic instruction.
Review the software settings in the
Setup Summary.
Click Next.
With the USB cable connected, test
the communication settings by
selecting Yes. Click Next to initiate
the test. To troubleshoot an
unsuccessful test, see Section
9,
Troubleshooting
(p. 52). Click Next
again after a successful test.
The Datalogger Clock window
shows the current time for both the
CR300 and the PC. Set the
datalogger clock to the Adjusted
Server Date/Time by clicking Set
Datalogger Clock. Apply time
offsets in Time Zone Offset.
Click Next.
To Next Page
Loading...
