CR300-Series Datalogger
14
4.4 Wire Sensors and Devices
If the program was created in Short Cut, follow the wiring diagram created by
Short Cut to attach sensors and devices to the datalogger. The wiring must
match the diagram exactly for the sensors to be measured correctly.
If the program was created directly in the CRBasic Editor, attach sensors and
devices according to the options chosen for the measurement instructions and
according to their individual product manuals.
To open a terminal on the CR300, use the included flat-blade screwdriver. This
is shown in FIGURE 4-1 below.
FIGURE 4-1. Opening a Terminal
4.5 Send a Program
Watch the video for Sections 4.5 – 4.7: CR300 QuickStart Part 4.
Connect to the datalogger as shown
in Section 4.2, Connect to the
The Current Program section
shows the program currently
running on the CR300. Click Send
New or Send Program… to send a
new program to the datalogger.
Select the program to send, and
Send the program created in Section 4.3, Create a Program (p. 9). Browse to the C:\Campbellsci\SCWin folder.
Select MyTemperature.CR300 file. Click Open.
To Next Page
Loading...
