Campbell CR300 series - 4.2 Sensors

CR300-Series Datalogger
13
Add measurements to the table by
selecting them under Selected
Sensors and then clicking on an
output processing option in the
center column of buttons.
Click Finish to compile the
program. Give the program a name.
A summary screen will appear
showing the compiler results. Any
errors during compiling will be
displayed.
If LoggerNet, PC400, or PC200W is
running on your PC, and the PC-to-
datalogger connection is active, you
can choose to send the program. See
Section
4.1, Configure Software (p.
3)
, for setting up an active PC-to-
datalogger connection with
datalogger support software.
Select BattV under Selected Sensors and then click Average. Repeat this procedure for PTemp_C and Temp_C.
Give the program the name MyTemperature. Save it in the default C:\CampbellSci\SCWin folder. Do not send the
program at this time.
Click No. Do not send the program here. You will do this in Section 4.5, Send a Program (p. 14).